CUBIC ZIRCONIA,Cubic Zirconia Jewelry,CZ Rings, Bodyjewels

How We Make Your Custom Jewelry At BodyJewels.Com Cubic Zirconia Jewelry At Its Finest!
	Need a Custom Order or Design! Just give us a call at 877-469-2485 or email your image to custom@bodyjewels.com with your phone number and we can custom make anything just for you with synthetic stones hybrid diamonds cubic zirconia or any genuine stones you need in 14kt 18kt gold two tone and platinum as well as padillium.
	Mold Making To produce a jewelry item, you must first design an original item. Then the item must be packed tightly with raw rubber inside a metal frame. After heating and curing the rubber for about one hour, the ring is ready to be cut out of the cured rubber
	Cutting The Mold Now it is time to cut the rubber and remove the original model. This is not as easy as it may seem, cutting a mold properly takes many years of practice. Some molds have up to 8 individual pieces that have to fit together like a puzzle.
	Injecting The Wax Now that the original model has been successfully cut out, a cavity is left in the rubber mold which we will inject wax into. Hot wax is forced into the cavity by pressure with a commercial wax injector
	Building A Ring Tree The wax rings are cleaned and attached to a wax sprue making ready for investing and casting.
	Attaching Wax Tree To Rubber Base The ring tree is attached to a rubber base.
	Metal Flask A metal flask is placed around the tree making a water tight container to prepare for the next step.
	Mixing Investment A mixture called investment is mixed with water.
	Vacuum The investment must be placed in a vacuum chamber to remove all air bubbles from the solution.
	Oven After about one hour of drying , the flask is placed in an oven where it is heated to about 1350 degrees. The wax ring tree is melted away leaving a cavity just like the wax tree. This is where the process gets it's name "Lost Wax Casting".
	Casting After burnout is complete, the flask is placed in the centrifugal casting machine where gold is melted and forced into the cavity in the flask.
	Gold Tree The results are a gold ring tree exactly like the wax tree that we started with.
	Cutting The rings are now cut off the sprue with hydraulic cutters.
	Roughing Each ring is now hammered flat and rounded on a ring stick, then sanded and shaped to prepare for the tumbling process.
	Tumbling The tumbling process is next. This is a series of rough to fine coarse media that takes about three days to complete. The results is a ring that is bright and shiny and ready for stone setting.
	Setting Each setting is drilled and the stones are set.
	Polishing After setting , the ring is now ready for polishing. Polishing is about a 10 step process of several grits of abrasives until a fine finish is accomplished.
	Cleaning The last process is to thoroughly clean the product in an ultrasonic cleaning machine, dried and ready for sell.